Jeep Wrangler Door Panel Retainer Clips

If you’re like most Jeep Wrangler owners, you probably don’t think much about the door panel retainers clips that help to keep your door panels in place. But if one of these clips breaks, it can be a real pain to try to replace it. Here’s a quick guide to replacing a broken door panel retainer clip on your Jeep Wrangler.

If you own a Jeep Wrangler, then you know that one of the most annoying things is dealing with door panel retainers. These little clips are responsible for holding your door panel in place, but they have a tendency to fall out and get lost. Thankfully, there’s an easy way to deal with this problem.

All you need is a set of replacement retainer clips. You can find these at most auto parts stores, or even online. Once you have your new clips, simply pop them into place and voila!

Your door panel will be secured once again. So next time your Jeep Wrangler’s door panel retainers come loose, don’t fret. Just grab some replacements and put them back in place.

It’s quick, easy, and will save you from having to buy a whole new door panel!

Jeep Door Panel Retainer Clips

If your Jeep’s door panels are starting to sag or become loose, it might be time to replace the door panel retainer clips. These small plastic clips are responsible for holding the door panel in place, and over time they can become worn out or broken. Replacing them is a fairly easy process that anyone can do at home with a few simple tools.

To start, you’ll need to remove the old clips from the door panel. You can do this by gently prying them out with a flathead screwdriver. Once they’re removed, take a look at the back of the door panel to see how the new clips will need to be installed.

There will likely be four holes in the panel – two large ones near the top, and two smaller ones near the bottom. Next, install the new clips by pushing them into place until they snap into position. Make sure that they’re pushed all the way in so that they’re flush with the back of the door panel.

Once all four clips are in place, you can reinstall the door panel on your Jeep. Start by lining up the top two holes, then push down on the rest of the panel until it clicks into place. That’s it!

Your Jeep’s door panels should now be securely fastened in place thanks to your new retainer clips.

How Do I Remove the Door Panel on a Jeep Wrangler

Assuming you would like steps on how to remove a door panel from a Jeep Wrangler: 1. start by removing the screws at the bottom of the door panel. There are usually 3 of them.

2. Once those are removed, there will be snaps along the top of the door panel that need to be unsnapped. Start from the front and work your way back. 3. The last thing holding the door panel on will be the electrical wire harness for the window controls and mirror adjuster.

There is a plastic clip holding this in place which can be pried off with a small flathead screwdriver or knife blade. Be careful not to damage any wires while doing this step.

jeep wrangler door lock retainer clip removal

Conclusion

If you own a Jeep Wrangler, then you know that the door panels can be a pain to keep in place. But there’s an easy fix for that: Jeep Wrangler Door Panel Retainer Clips! These little clips will keep your door panels securely in place, so you don’t have to worry about them falling off every time you open your doors.

Plus, they’re super easy to install – just pop them into place and you’re good to go. So if you’re sick of constantly adjusting your door panels, pick up some Jeep Wrangler Door Panel Retainer Clips and make your life a whole lot easier.