In 1989, the Jeep Wrangler fuel filler hose was made of a tough, flexible material that could withstand extreme temperatures and harsh weather conditions. This hose was designed to connect the fuel tank to the fill tube, and it was an essential part of the Jeep’s fuel system. The filler hose was often exposed to the elements and had to be replaced frequently.
If you own a 1989 Jeep Wrangler, chances are you’ve had to replace the fuel filler hose at some point. This is a common issue with Jeeps of this era, and it’s usually caused by age and exposure to the elements. The good news is that replacing the fuel filler hose is a relatively easy process, and it doesn’t require any special tools or knowledge.
We’ll walk you through the process step-by-step so you can get your Jeep back on the road in no time.
How to replace Fuel Filler Neck for a 1987-90 Jeep YJ
Jeep Wrangler Fuel Filler Hose Replacement
If you own a Jeep Wrangler, it’s important to know how to replace the fuel filler hose if it ever needs to be replaced. This is a relatively easy repair that anyone can do with a few tools and some time. The first step is to disconnect the negative battery terminal.
This will prevent any sparks from happening when you are working on the jeep. Next, remove the gas cap and set it aside. After that, locate the fuel filler hose which is located under the jeep near the gas tank.
There are two bolts holding the fuel filler hose in place. Remove these bolts and then carefully pull off the old fuel filler hose. Be careful not to damage anything as you remove it.
Once it’s off, inspect the area for any debris or damage before installing the new fuel filler hose. To install, simply reverse the process and bolt everything back in place securely. Once that’s done, reconnect the battery terminal and test out your new fuel filler hose by filling up your gas tank!
-Where is the Fuel Filler Hose Located on a 1989 Jeep Wrangler
The fuel filler hose on a 1989 Jeep Wrangler is located under the hood, on the driver’s side of the vehicle. It is connected to the fuel tank via a metal or plastic tube. The hose itself is made of rubber and has a threaded cap that screws onto the filler neck.
To fill the tank, unscrew the cap and insert the nozzle of the pump into the hose.
If your Jeep Wrangler is from the 1989 model year, then you may need to replace the fuel filler hose. This is a relatively easy process, and this blog post will walk you through the steps. You’ll need to gather a few tools and supplies before getting started, and then it’s just a matter of following the instructions.
With a little bit of effort, you can have your Jeep running like new again.